Left Side of Gun:
Notice the wire holding the barrel to the shooting mechanism and the foam tape keeping
the two pieces slightly apart from each other, this is because a gap is needed in order
for it to shoot properly.

Right Side of gun:
Notice that the wire is lashed so that it can be tightened without pulling
the entire barrel upwards.

Bottom of Gun:
Here is the hole where the ammo enters. We took the extra plastic barrel and fit it over this by flairing it slightly
on one end so the inner diameter of the extra barrel fits over the outer diameter of this hole. we will be
trying to substitute surgical tubing for the extra barrel so it looks cleaner and can hold more ammo.